The stuffing box is perhaps the most important piece to your artificial lift surface hookup. It is your SEAL, after all. The most important component to the stuffing box sealing, is the packing inside the stuffing box. WSI continually tests new and better materials to meet the demands for ever-changing well conditions. By working with rubber manufacturers and field testing new designs, WSI wants to make certain that our packing stands up to stringent durability and performance standards. Cone packing is available in sizes for all polished rods 1” through 1 - 3/4” in sets of 4 (3 top cone and 1 bottom cone).

Economy Cone & “V” Style Packing:

soft cone packing:

  • For sweet crudes with high oil-to-water ratios and low abrasives

Teflon cone packing:

  • For sweet crudes with low oil-to-water ratios and/or for reducing polish rod noise in noise-sensitive areas

Fluid seal™ cone packing:

  • For 3000 PSI applications and Pressure energized seal

high temp cone packing:

  • For steam injection wells

    producing sweet crude

brass filled cone packing:

  • For sweet crudes with high oil-to-water ratios and low abrasives. Good for reducing polish rod scale buildup

hard cone packing:

  • For sweet crudes with low oil-to-water ratios

hsn cone packing:

  • Excellent For H2S and CO2 wells

crown ring packing:

• For use with economy stuffing boxes

“V” style packing:

• Available in NBR or HSN compounds. Used in E-LUG™ for both “Classic” and “Premium” stuffing box models

premier packing:

KB™ Cone Packing:

A Kevlar brass packing for sweet crudes with high oil-to-water ratios. Good in CO2 & H2S with excellent abrasion resistance. High temperature characteristics, most proven cone compound for steam applications. Also available in crown rings.

Super Life™ 575 Polyurethane Cone packing:

A polymer packing designed for high water cut applications. Good abrasion resistance. Good against gas decompression due to polymer makeup.

 

SB Cone Packing

A silicone packing for sweet crudes with high oil-to-water ratios and low abrasives. Also available in crown rings.

“Super Dome™” Packing

Low coefficient of friction reducing heat build up and polished rod drag. Excellent chemical resistance and great wear characteristics in most well conditions. One time conversion kit to retrofit most cone packing stuffing boxes. Greatly reduces stuffing box failure and maintenance cost.

NOTE: All packing rubbers life expectancy can be increased with the use of a polished rod lubricator. Especially for wells on timers that may stop on the upstroke.

**Important Note: The guidelines on this page are for general purposes only and should not be used as the sole determining factor for packing material selection. Each down hole condition is different and must be addressed on a case-by-case basis to determine the best material solution for your particular well condition.
* Aflas is a registered trademark of Aashi Glass Co. Ltd.